Filter
Top Products
2.2.9 Internal connectors
1. Intel
®
X79 Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_1/2 [gray])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
• These connectors are set to [IDE Mode] by default. If you intend to create
a Serial ATA RAID set using these connectors, set the SATA Mode item in
the BIOS to [RAID Mode]. Refer to section 3.5.4 SATA Conguration for
details.
• Before creating a RAID set, refer to section 4.4 RAID congurations or the
manual bundled in the motherboard support DVD.
• When using hot-plug and NCQ, set the SATA Mode in the BIOS to [AHCI
Mode]. Refer to section 3.5.4 SATA Conguration for details.
• You must install Windows
®
XP Service Pack 3 or later versions before using
Serial ATA hard disk drives. The Serial ATA RAID feature is available only if
you are using Windows
®
XP SP3 or later versions.
• You must load
IRST Driver
during OS installation for the system to detect
the Optical Disk Drive (the ODD should be connected to the SATA_3G
port), or else the ODD will not run.
®
ASUS P9X79 WS 2-23