Filter
Top Products
26 ASUS P/I-P55T2P4S User’s Manual
III. INSTALLATION
(Connectors)
III. INSTALLATION
5. Floppy Drive Connector (34-pin block )
This connector supports the provided floppy drive ribbon cable. After connect-
ing the single end to the board, connect the two plugs on the other end to the
floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-
tion when using ribbon cables with pin 5 plugged).
Floppy Drive Connector
Pin 1
Connect the Red stripe to Pin 1
6. Power Connector (12-pin block)
This connector connects to a standard 5 Volt power supply. To connect the leads
from the power supply, ensure first that the power supply is not plugged. Most
power supplies provide two plugs (P8 and P9), each containing six wires, two of
which are black. Orient the connectors so that the black wires are located in the
middle.
Using a slight angle, align the plastic guide pins on the lead to their receptacles
on the connector. Once aligned, press the lead onto the connector until the lead
locks into place.
Power Connector
Power Plugs from
Power Supply
P9
P8
ORG
RED
YLW
BLU
BLK
BLK
BLK
BLK
WHT
RED
RED
RED
Power Connector
on Motherboard
PG
+5V
-12V
-5V
GND
+5V
+12V