Asus SP97-V Computer Hardware User Manual


 
28 ASUS SP97 / SP97-V User’s Manual
III. INSTALLATION
(Connectors)
III. INSTALLATION
5. Power Supply, Chassis Fan Connectors (PWR_, CPU_, CHA_FAN, 3 pins)
This connector supports a 3-pin cooling fan of 500mAmp (6watts) or less with a
minimum of 3,500RPM. Depending on the fan manufacturer, the wiring and
plug may be different. The red wire should be Positive and the black wire should
be Ground.
WARNING! Damage may occur to the motherboard and/or the fans if these
pins are incorrectly used.
DO NOT PLACE JUMPER CAPS OVER THESE PINS.
12Volt CPU Fan Power
Power Supply, CPU Fan Power
Chassis Fan Power
(NC)
Ground
+12 Volt
R
6. Primary/Secondary IDE Connectors (two 40-1 pin blocks)
These connectors support the provided IDE hard disk ribbon cable. After con-
necting the single end to the board, connect the two plugs at the other end to
your hard disk(s). If you install two hard disks, you must set the second drive to
Slave mode. Refer to the documentation of your hard disk for the jumper set-
tings. BIOS now supports SCSI device or IDE CD-ROM bootup (see HDD Se-
quence SCSI/IDE First & Boot Sequence in the BIOS Features Setup of the
BIOS SOFTWARE) (Pin 20 is removed to prevent inserting in the wrong
orientation when using ribbon cables with pin 20 plugged).
IDE (Hard Disk Drive) Connectors
Primary IDE Connector
Pin 1
Secondary IDE Connector
Orient the red stripe on the
IDE ribbon cable to pin 1
R
TIP: You can configure two hard disks to be both Masters using one ribbon cable
on the primary IDE connector and another ribbon cable on the secondary IDE
connector. You may install one operating system on an IDE drive and another on a
SCSI drive, and then select the boot disk through the BIOS Features Setup.