Filter
Top Products
2-25
ASUS T2-PH2
7. Connect the 4-pin power plug to the power connector of the floppy
disk drive.
8. Connect the 4-pin power plug(s) to the power connector of the
optical drive(s).
9A. Connect the 4-pin power plug to the power connector of the IDE hard
disk drive, or the Serial ATA hard disk drive with a 4-pin power plug.
- or -
9B. For Serial ATA hard disk drive without a 4-pin power plug, connect
the 15-pin SATA power adapter plug to the power connector at the
back of the drive, then connect the other end (4-pin male) to a 4-pin
(female) power plug from the power supply unit.
Voltage selector
The PSU has a 115 V/230 V voltage selector
switch located beside the power connector. Use
this switch to select the appropriate system
input voltage according to the voltage supply in
your area.
If the voltage supply in your area is 100-127 V,
set the switch to 115 V.
If the voltage supply in your area is 200-240 V,
set the switch to 230 V.
230
Setting the switch to 115 V in a 230 V environment will seriously
damage the system!
See the Appendix for the power supply specifications.
Power supply unit plugs
2
7
8
9B
9A
1