Filter
Top Products
ASUS TXP4 User’s Manual 19
III. INSTALLATION
(System Memory)
III. INSTALLATION
2. System Memory (SIMM & DIMM)
This motherboard supports four 72-pin, 32-bit SIMMs (Single Inline Memory Mod-
ules) of 4, 8, 16, 32, or 64MB to form a memory size between 8MB to 256MB. The
SIMMs can be either 60ns or 70ns Fast Page Mode (FPM) (Asymmetric or Sym-
metric), or Enhanced Data Out (EDO) (BEDO & Parity are not supported). SIMMs
must be installed in pairs so that each Row (see motherboard layout for row loca-
tions) contains 64-bits of the same size and type of memory chips. One side (with
memory chips) of the SIMM module takes up half a row on the motherboard.
Dual Inline Memory Modules (DIMMs) can be used when the SIMM sockets are
not used. Two sockets are available for 3.3Volt (power level) Unbuffered Synchro-
nous DRAMs (SDRAM) or EDO DRAM of either 8, 16, 32, 64, 128, 256MB to
form a memory size between 8MB to 256MB. One side (with memory chips) of the
DIMM module takes up one row on the motherboard.
IMPORTANT: Memory speed setup is required through “Auto Configuration” in
BIOS Chipset Setup of the BIOS SOFTWARE. If both 60ns and 70ns memory are
used, set “Auto Configuration” to 70ns. Do not use memory modules with more than
18 chips per module. Modules with more than 18 chips exceed the design specifica-
tions of the memory subsystem and will be unstable.
Memory Socket SIMM Memory Module Total Memory
SIMM Sockets 1&2 4MB, 8MB, 16MB, 32MB, 64MB x2
(Rows 0 & 1) 72-pin FPM or EDO SIMM
(DIMM Sockets must be empty)
SIMM Sockets 3&4 4MB, 8MB, 16MB, 32MB, 64MB x2
(Rows 2 & 3) 72-pin FPM or EDO SIMM
(DIMM Sockets must be empty)
Total System Memory (Max 256MB) =
WARNING! Do not install both SIMMs and DIMMs at the same time or else you
will burn your memory. Mixing SIMMs and DIMMs require 5.0Volt (signal level)
tolerant memory chips which are currently unavailable.
Memory Socket DIMM Memory Module Total Memory
DIMM Socket 1 8, 16, 32, 64, 128, 256MB x1
(Rows 0 & 1) 168-pin SDRAM or EDO DIMM
(SIMM Sockets must be empty)
DIMM Socket 2 8, 16, 32, 64, 128, 256MB x1
(Rows 2 & 3) 168-pin SDRAM or EDO DIMM
(SIMM Sockets must be empty)
Total System Memory (Max 256MB) =