Filter
Top Products
-8-
CHANNEL TUNING SETUP
In order to easily access all available channels, it may
be necessary to perform the channel Auto-
Programming procedure whenever the vehicle’s
geographic location has changed, i.e. city-to-city,
weak signal area.
1. Press the AUTO MEMORY button on the remote
control unit or the AUTO PROGRAM button on the
flip down video unit. You will see the TV cycle
through all its channels. The built-in
microprocessor will automatically note each
channel that is actively broadcasting in your area.
(A) To tune only strong clear channels with the
CHANNEL UP/DOWN buttons, press the
SKIP/SEARCH button on the Remote Control
Unit until “SKIP MODE ON” is displayed on the
bottom of the screen. The TV will now tune
only to strong active channels when the UP o
r
DOWN buttons are used on the monitor or the
remote control.
(B) To tune to weak or marginal channels with the
CHANNEL UP/DOWN buttons, press the
SKIP/SEARCH button on the Remote Control
Unit until “SKIP MODE OFF” is displayed on the
bottom of the screen. Tune to the desired
channel using the CHANNEL UP/DOWN
buttons or go directly to the channel by using
the 0-9 buttons on the Remote Control.
2. To ERASE a channel, press the ERASE/WRITE
button on the Remote Control Unit until “MANUAL
MEMORY XX ERASE” is displayed on screen. To
STORE a channel, press the button until the
MANUAL MEMORY XX ADD is displayed on
screen.
TURNING THE VOH802 DL ON AND OFF
1 Sliding the screen release lock forward viewing will
unlock the screen and it will drop down slightly.
(Pivot the screen downward until a comfortable
angle is reached). After the unit has been turned
on and is displaying a picture, adjustment to the
viewing angle can be made by pivoting the screen
to optimize the picture quality. The internal friction
detent will hold the screen in position while the
system is in use.
2 Pressing the power button on the pod or remote will
alternately turn the system on or off. When in use
the internal back lighting will illuminate the controls.
3 Remember to turn the unit off and pivot the display
screen to the locked position when not in use.