Filter
Top Products
43
CONTENTS
4.2 CONFIGURATION AND MONITORING
ALS
20x
256
GB
Label position on the product
Prerequisites:
– The label length must be specified.
– The label stop position must be set.
Configuration in dispensing mode:
£ Use the two right buttons to set the start offset (see
“Online settings” on page 22).
Or use the function menu settings:
£ Call the LABEL SETUP > Start Offset function and set the
start offset.
– The label should be flush with the front edge of the
product:
£ Enter the distance between the product sensor and
the dispensing edge [47A].
– The label should be stuck at a distance from the
front edge of the product:
£ Increase the start offset by the distance [48A] to the
product’s front edge.
[47] Distance between the product sensor (left) and the
dispensing edge (right).
A
[48] Distance (A) between the label and the product’s front
A