Filter
Top Products
RoadRunners Evolution –L (1D) & -LA (Laser) – Programming Guide v1.8 - 5 -
Data Capture
for Workforce
in Motion
Introduction
The RoadRunners Evolution scanner can be programmed by scanning barcode labels which contain commands
for the decoder.
Programming labels must be Code128, with specific starting and ending characters. These labels will always be
read, even if Code128 symbology is disabled.
The scanner will acknowledge a good and valid programming barcode label reading with two beeps and a green
enlightening of the led. It will give two other beeps (lower tone) and a red enlightening of the led for either an
invalid or bad reading.
Please do not read the programming barcodes while being connected to the BaracodaManager software.
Programmable options are divided into 2 groups. The first group includes the options that show the general
behaviour of the scanner. The second group sets the decoding parameters for each barcode symbology.
This document concerns the Roadrunners 1D Evolution scanners, that is the BRR-L Evolution and the BRR-LA
Evolution.
All our documentations can be downloaded from the Partners download section of Baracoda website
(registration is required):
http://www.baracoda.com