Filter
Top Products
3. Physical Installation of the D320L Digitizer
3. PHYSICAL INS TALLATION OF THE
D320L DIGITIZER
3.1 Installatio n r equ irements
Requirements
• The D320L Digitizer should not be placed in a built-in installation or enclosure unless proper ventilation
is provided.
• When using the unit in a multi-unit rack assembly or closed assembly, the ambient temperature inside
the assembly may not exceed the maximum rated ambient temperature of the Digitizer. The instal-
lation should be such that the amount of air flow required for safe operation of the equipment in not
compromised.
• When building in the D320L Digitizer into a rack with cover door, be aw
are that a space of 8,5 cm is
needed between the indicated reference and the cover door. This space is needed to guide the input
cables to the inputs.
Image 3-1
A Reference
• The D320L Digitizer will require that air flow
s freely in vent holes. Blocking these holes will gr eatly
reduce the reliability of the unit and lead to the possibility of overheating.
• The D320L Digitizer should operate from an AC power source. The D320L Digitizer is equipped with
Power Supply Autoranging from 85 to 264 volt (50–60 Hertz).
• When installed in a rack, the mounting should be s uch that no hazardous condition is achieved due
to uneven mechanical loading.
• When the mains switch located on the back of the D320L Digitizer is not accessible due to rack mount-
ing, the socket outlet supplying the rack shall be installed near the equipment and be easily accessible
or a readily accessible disconnect device shall be incorporated in the fixed wiring. When using a rack
in an installation is advisable to log the serial number of the device and to activate the warranty figure
by registering utilizing the included form.
• Do not place the D320L Digitizer on an unstable cart, stand or table. The device may fall, causing
serious damage to it.
R5976542 D320L DIGITIZER 15042003
9