Filter
Top Products
Connections
3-6 5975977 BARCODATA 708 260597
(R-Y)Y(B-Y)3S or (R-Y)Y3s(B-Y) input selection
a. Press digit button 6 on the RCU or
b. With the local keypad :
(to gain access to the local keypad, see 'Local keypad' in chapter
'Location and function of controls'.)
- Press
ADJUST key, the General access menu is displayed on
the screen.
- Use the control disk to highlight
6.
- Press ENTER to select the highlighted source.
GENERAL ACCESS
Select with ,
or
then <ENTER>.
<EXIT> to return
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
5 6
3 4
1 2
Enter ADJUST
Connecting a computer, e.g. IBM PC (or compatible), Apple Macintosh to the RS232 input of the projector.
The projector has a RS232 port that allows it to communicate with a
computer.
Applications: remote control and data communications.
a) remote control:
- easy adjustment of the projector via IBM PC (or compatible) or
MAC connection.
- allow storage of multiple projector configurations and set ups.
- wide range of control possibilities.
- address range from 0 to 255.
b) data communications:
- sending data to the projector or copying the data from the projector
to a hard memory device.
COMM PORT
(800 peripherals)
REMOTE
SVIDEO
S-VIDEO
RG(S)B
R-Y Y(S)
B-Y
RS232 O UTRS232 IN
RS232
connection
Connecting a RCVDS 05 switcher to the projector.
- Up to 10 inputs (20 inputs when video and S-video) with the RCVDS
05 switcher and up to 90 inputs when 10 RCVDS switchers are
linked via the expansion modules.
- Serial communication with the projector.
- Remote control buttons on the RCVDS to control the projector
(source selection and analog settings)
- The selected source number will be displayed on a 2 digit display and
the selected input modules will be indicated with a LED on the rear.
For more information about the use of the RCVDS 05, consult the
Owner's Manual, order number: R5975765.
Connecting a VS05 switcher to the projector.
The VS05 can switch up to 5 Composite Video sources, 3 S-Video
Sources and 1 RGB analog or component Video source to the
projector. In addition, the audio signal proper to the source, can be
switched to an audio amplifier.
Order number : R9827890.
For more information about the use of the VS05, consult the Owner's
Manual, order number: R5975245.
Peripheral equipment
Connecting an IR Remote Receiver to the
projector
This infra-red receiver unit makes it possible to control the projector
from another room. There is a communication line cable between the
IR receiver and the projector or the RCVDS. The infrared control
information from the Remote Control Unit is sent to the IR Remote
Receiver. The IR Remote Receiver 800 displays the selected source
on a 7-segment display.
Order number : R9827515.