Filter
Top Products
Connections
3-1
5975039 BARCOVISION 508 120198
CONNECTIONS
Power (mains) cord connection
Use the supplied power cord to connect your projector to the
wall outlet. Plug the female power connector into the male
connector at the rear of the projector.
The projector is switched ON and OFF using the power
(mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image
displayed) or in the 'stand by mode', depending on the position
of the 'power up' dip switch on the controller unit. This DIP
switch is set during installation by a qualified technician. If
you want to change this start up mode, call a qualified
technician.
Switching on/off
Signal input connection to the projector :
- Composite Video
- S-Video
- RGBS or RGsB
- YsUV or YUVS [component input]
Stand by indication lamp :
No light up : Projector in operational mode
Red : Projector is in stand by.
Leds on the rear plate of the projector
STD BY / NORMAL
PAUSE
COINCIDENCE
EHT HOLD DOWN
IR CODE RXD
2 1
3
Source No Projector input Press digit button
1 Comp. Video 1
2 S-Video*
3 RGsB 4
3 RGBS 5
3 YsUV 6
3 YUVS 7
* Input signal Y/C (luma/chroma)
120/230 V
4/2.5 A
60/50 Hz
300 W
3