Barco R5975039 Projector User Manual


 
Location and Functions of Control
2-3
5975039 BARCOVISION 508 100698
BARCO key : When a RF-tuner is built in (option), this key
used to toggle between Video and tuner signal.
ADJ. : adjust key, to enter or exit the adjustment mode.
Address key (recessed key), to enter the address of the
projector (between 0 and 9). Press the address key,
followed by pressing one digit button between 0 and 9.
STBY : stand by button :
- to initiate remote power up operation
- to stop projection without main power off.
Pause :to blank the image, press PAUSE. The image
disappears but full power is retained for immediate restart-
ing.
Mute : the piture stays while the audio is turned off. The
power for the amplifiers stays.
Help.
Digit buttons : direct input selection.
Audio control : use these buttons to obtain the desired
level (see also 'Controlling') for each audio function.
Picture controls : use these buttons to obtain the desired
level (see also 'Controlling') for each picture function.
1
2
3
4
TEXT :
During Video or RGB operation : when adjusting one of the
image controls during a meeting, the displayed bar scale
can be removed by pressing 'TEXT' key first. To re-display
the bar scale on the screen, press 'TEXT' key again. 'TEXT'
key is only active in operational mode. When 'TEXT' is off,
no warning message will be displayed.
When in Tuner mode : this key is used to activate teletext.
FREEZ : When in teletext mode (only when the tuner option
is installed) this key is used to freez the actual page.
ENTER : to start up the adjustment mode or to confirm an
adjustment or selection in the adjustment mode.
EXIT : to leave the adjustment mode or to scroll upwards
when in the adjustment mode.
Control disc : to make menu selections when in the
adjustment mode. Also allows to increment or decrement
an adjustment in the adjustment mode.
control disc up = up arrow in the menus
control disc down = down arrow in the menus
control disc to the right = arrow to the right on the menus
control disc to the left = arrow to the left on the menus
RC operating indication : lights up when a button on the
remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
5
6
7
10
11
12
8
9
13
14
15
16