Barco R5975039 Projector User Manual


 
Start Up of the Adjustment Mode
5-25975039 BARCOVISION 508 120198
RANDOM ACCESS - Random Access should be selected if the user intends to make
only a few adjustments.
SERVICE - Service should be selected if the user intends to delete blocks, change
password or apply information.
Some items in the Adjustment mode are password protected. While selecting such
an item, the projector asks you to enter your password. (Password protection is only
available when the password DIP switch on the controller module is in the ON position.
Contact a BARCO authorized technician when no password is requested during the
adjustment procedure and password protection is desired.)
Your password contains 4 digits.
a) Adjusting the projector with the RCU.
Enter the digits with the numeric keys on the RCU.
Example : 2 3 1 9
For each digit entered, a 'X' appears on the screen under the displayed text 'enter
password'.
When your password is correct, you get access to the 'Adjustment mode'.
When the entered password is wrong, The message 'Wrong password !!!' will be
displayed. The projector stays on the previous selected item.
Factory programmed
password : 0000
b) adjusting the projector with the local keypad.
When the 'compose password' menu is displayed, select with control disk the first
digit of your password and press ENTER. Continue by selecting the second digit with
the control disk and press ENTER. Handle in the same way for the third and fourth
digit.
When your password is correct, you get access to the 'Adjustment mode'.
When the entered password is wrong, the message 'Wrong password' will be
displayed.
Once the password is correctly entered, all other password protected items are
accessible without re-entering your password.
When re-entering the adjustment mode, it will be necessary to enter your password
again when selecting a password protected item.
While in Guided or Random Access adjustment Mode, the user may use an external
source, an internally generated genlocked pattern or an internally generated
multifrequency cross hatch pattern as a setup pattern.
Warning during the start up of the installation mode.
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 1
Select with or
then <ENTER>
<EXIT> to return.
enter
password
xxxx
wrong
password
!!!
COMPOSE
PASSWORD
???
7 8 9
4 5 6
1 2 3
0
Select with ,
or
then <ENTER>
<EXIT> to return.