Filter
Top Products
5-1
Connections
5976069 BARCOREALITY 6400 14032000
5
SDI
SDO
S-VIDEO
VIDEO
COMPUTER
IEEE 1394
TRIG
MOUSE
MONITOR
RS232 IN RS232 OUT
AUDIO IN AUDIO IN AUDIO IN AUDIO IN
COMM. PORT
RC
CB
A
R
GBH/CV
5
6
2
1
43
SDI
S-VIDEO
VIDEO
43
Projector mode indication
F1
F2
F3
F4
F5
ADJ
EXIT
ENTER
PAUSE
PHASE
TEXT
SHARPN
TINT
COLOR
BRIGHTN
CONTR
TREBLE BALANCE
BASS
VOL
90
78
5
6
34
1
2
COLORPHASE
SHARPN TINT BRIGHTN
STANDBY
ENTER
TEXT
EXIT
PAUSE
2
1
4
3
5
6
8
0
9
7
CONTRAST
Stand-by key
Fuses
Warning
For continued protection against fire hazard :
- refer replacement to qualified service personnel
- ask to replace with the same type of fuse.
Fuse type : T10 AH/250V
Switching on
Use the power switch to switch on.
When '0' is visible, the projector is switched off.
When '1' is visible, the projector is switched on.
When switching on with the power switch, the projector starts in
the stand by mode. The projector mode indication lamp is red.
To start image projection :
a. press the 'Stand by' button once on the local keypad or on the
remote control. The projector mode indication lamp will be green.
b. press a digit button to select an input source. The projector
mode indication lamp will be green.
CONNECTIONS
Power connection
AC Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector at the
front of the projector.
100-240 V
6-2.5 A
50-60 Hz
The power input is auto-ranging from 90 to 240 VAC.