Filter
Top Products
7-1
Auto Image Adjust
5976069 BARCOREALITY 6400 21082000
8
AUTO IMAGE ADJUSTMENT
Auto Image Adjustment
Push the cursor key é or ê to highlight 'Auto Image' and press ENTER.
With auto image, it is possible to switch the auto image function 'on' or 'off' and to adjust an
existing image when the auto image function is off.
ADJUSTMENT MODE
Select a path from below :
AUTO IMAGE
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with or
then <ENTER>
<EXIT> to return.
Adjust
By selecting Adjust the image will be centered on the active area of the LCD surface.
The centering will be done by adapting the values for 'pixel start', 'pixel end', 'line start'
and 'line end'.
To center the image :
1 Push the cursor key é or ê to highlight 'Adjust'.
2 Press ENTER to activate. The image will be centered on the LCD surface.
This is the same function as the '?' key on the remote control when in
operational mode.
The menu is automatically exited.
The adjustment values will be saved when switching to another source.
Select with or
then <ENTER>
<EXIT> to return.
AUTO IMAGE
ADJUST
ACTION : FULL AUTOMATIC
Select with or
then <ENTER>
<EXIT> to return.
ADJUSTMENT MODE
Select a path from below :
AUTO IMAGE
RANDOM ACCESS
INSTALLATION
SERVICE
Action
The action function can be toggled between :
- full automatic
- on new file
- manual
[full automatic] : the best fitting file will be loaded automatically when a source is selected.
At the same time the image will be automatically centered on the active surface of the
LCD.
The centering of the image will be disabled when :
1 The black edges of the image take more than 25% of the complete image.
2 The connected source is video, s-video, digital video or HDTV.
3 Custom file already exists.
[on new file] : only on a new file, the image will be centered on the active surface of
the LCD.
[manual] : the auto image function is switched OFF, no centering, no file load.
To setup the Action function :
1 Push the cursor key é or ê to highlight 'ACTION'.
2 Press ENTER to toggle between FULL AUTOMATIC, ON NEW FILE and
MANUAL.
The values of automatically adjusted sources will not be saved.