Filter
Top Products
Installation setup
4-1
5975607 BARCODATA 808s 170397
4
INSTALLATION SETUP
Removing the top cover
During some installations, it will be convenient to remove the top cover
from the projector totally.
Proceed as follows :
Pivot the top cover backwards 90° (fully extended);
Push carefully the top cover to the left side (viewing from the rear
of the projector) until the hinges are disengaged. This can be
facilitated by pressing downwards on the spring tabs next to the
hinges. Slide the top cover off the projector.
Reinstalling the top cover
To reinstall the top cover on the projector :
Place the top cover in front of the hinges (as shown in the picture)
and push in the direction of the black arrow until the cover locks
into the hinges;
Pivot the top cover to close;
Secure the locking screw by turning it clockwise with a screw-
driver.
WARNING :
Risk of electric shock !
Installation only by BARCO authorized service personnel !
Access to Controls
Opening the top cover
During the projector setup and installation it is necessary to open the
top cover. Follow the procedure described below :
Turn the locking screw with a screwdriver counter clockwise;
Lift up and pivot the top cover.
WARNING :
The projector's top cover is not supported with locking hinge. Open
with care and support the cover with your hand.