Filter
Top Products
Projector setup
5-1
5975607 BARCODATA 808s 170397
5
PROJECTOR SETUP
StdBY
MA IN POWER
PROCESSOR CY
C
BLOCK MATCH
ERROR
RCU
RCVDS
PC
PA USE
PROJECTOR A DDRESS
(sum)
OFF ON
BAUD RATE TABLE
TO COMPUTER
POWER UP MODE
OPERATING MODE WHEN
POWER IS SWITCHED ON
ON
OFF
PLAYING
StdBY
PASSWORD MODE
ON
OFF
YES
NO
RESERVED
POWER UP MODE
PASSWORD MODE
BA UD RATE CODE
(sum)
PASSWORD REQUIRED
FOR ADJUSTMENT
CODE
0
1
2
3
4
5
6
7
SPEED
110
150
300
600
1200
2400
4800
9600
0
1
128
64
32
16
8
4
2
1
1
2
3
4
5
6
7
8
1
2
3
4
2
1
1
2
3
4
5
6
7
8
I
2
C SHORTED
Setting the projector address
The projector's address may be set to any value between 0 and 255.
When the address is set, the projector can be controlled now by :
RCU for addresses between 0 and 9.
IBM PC (or compatible) or Apple MAC for addresses between 0 and
255.
The DIP switches on the controller board allow the SETUP of the
projector :
8 DIP switches for setting the projector address.
1 DIP switch for setting the powerup mode.
3 DIP switches for setting the baud rate for communication.
1 DIP switch for setting the password mode.
To gain access to the DIP switches :
- Open the top cover.
- Loosen the retaining screws of the metal protection plate and pivot
this plate to the lens side (Please refer to Chapter 4 'Installation
setup').
The DIP switches are located on the back side of this metal protection
plate.
Addressable with RCU
Addressable with PC, MAC
or workstation
0
9
255
PROCESS CYCLE
I
2
C SHORTED