Filter
Top Products
Service Mode
7-2 5975688 BARCOVISION 1609s 131097
Select with or
then <ENTER>
<EXIT> to return.
Select with or
then <ENTER>
<EXIT> to return.
Select with or
<ENTER> to copy
<EXIT> to return.
Identification
Highlight 'Identification' with the control disk and press ENTER.
The 'Identification' screen gives information concerning :
- projector address. To change the address of your projector,
contact a qualified service technician.
- software version.
- configuration.
possible installations :
* front-ceiling
* front-table
* rear-ceiling
* rear-table
- baud rate PC : transfer speed for communication with an IBM PC
(or compatible) or MAC. The baud rate of the projector must be the
same as the baud rate of the connected computer. When there is a
difference, contact a qualified service
technician to make the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator
will be displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on
the RCU.
- Serial no. : indicates the fabrication number of the projector. This
number can be useful when calling for technical assistance.
Copy a block
The copy a block function copies the settings of a selected block into
the active block.
Highlight copy a block with the control disk and press ENTER.
ENTER will select the highlighted item.
To copy the settings of a closed block to the block you are working
on (active block), use the control disk to select a block.
All existing settings will be overwritten with the new settings.
Press ENTER to copy the selected block. A confirmation screen will
be displayed.
If you are certain you wish to copy the contents of the selected block
into the active block, press ENTER.
EXIT cancels the copy procedure and returns without copying the
block.
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Proj. address : 001
Soft. Version : 6.00
Config. :Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 103589552
VISION 1609s
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
COPY MODE
Nr. Src Fh Fv inp conf
1 1 15.650 video FC
2 3 31.260 RGB3SRT
3 - 15.650 intern FC
4 2 31.550 RGB3S FC
5 - 33.760 intern FC
6
7
8
Active block nr.
1
COPY BLOCK
All settings
in current block
will be overwritten !
<ENTER> to confirm
<EXIT> to cancel