Filter
Top Products
Adjustment Blocks and Source Numbers 90-99
B-1
5975688 BARCOVISION 1609s 131097
Adjustment Blocks (memory blocks)
As the projector is digitally controlled, all geometry and convergence adjustments are stored in the projectors memory as numeric values.
These numeric values are used to control digital potentiometers which in turn, control the projector. Each source connected to the
projector has a unique set of adjustment data which is automatically downloaded into the projectors digital potentiometers once the
source has been selected. This set of adjustment data is referred to as an adjustment block.
An adjustment table is automatically created for a source when the source is first connected to the projector and the Adjustment mode
is entered. If other sources have already been connected to the projector and geometry and convergence adjustments have been
performed on these sources, the projector will use Linear Digital Interpolation to create a new block for the new source. This block
will provide an initial set of adjustments for the new source that have been calculated by the projector from previous experience.
The projectors memory has the capacity to store 32 adjustment blocks. The adjustment block consists of two parts, the block header
and the data representing the values for all adjustments (eg. Convergence and Geometry) in the projector for the source the block
corresponds to. The block header contains the basic characteristics of the source and the projector configuration used to display
the source.
Block Header example of block header
Block Number 01
Source Number 01
Horizontal Frequency 15.6 kHz
Vertical Frequency 50 Hz
Input Type video
Scan Switch Configuration Front/Ceiling
The data representing the various adjustments for the source follows the block header.
Source numbers 90 - 99
Source numbers 90 - 99 do not correspond to physical inputs
to the projector or RCVDS. They are used to assign an
additional adjustment block to a source. This additional adjust-
ment block may contain different geometry and convergence
settings, sync fast/slow positions and enhanced blue on/off
settings. The relationship between source numbers 0 - 9 and
90 - 99 (projector with RCVDS) or 1 - 5 and 91 - 95 (stand-
alone projector) is shown in the diagram below.
source input 0
source input 2
source input 1
source input 9
source number 0
source number 90
source number 1
source number 91
source number 2
source number 92
Block header A
Block header A, differ-
ent analog settings
Block header B
Block header B, dif-
ferent analog settings
Block header C
Block header C, dif-
ferent analog settings
source number 9
source number 99
Block header J
Block header J, differ-
ent analog settings
B
ADJUSTMENT BLOCKS AND SOURCE
NUMBERS 90 - 99