Filter
Top Products
1. Safety Instructions
1. SAFETY INSTRUCTIONS
Overview
• General
• Warning Risk of Fire
• Ventilation
•Service
• Optical performances
• Cabinet maintenance
1.1 General
Summary
• This equipment is intended for installation in a restricted access location.
• Before operating your projector, please read this manual thoroughly, and retain it for future r eference.
• Installation and preliminary adjustments should be performed by qualified Barco personnel or authorized Barco service dealers.
• All warnings on the projector and in the added manuals should be adhered to.
• All instructions for operating and use of this equipment must be followed precisely.
• All local installation codes should be adhered to.
1.2 Warning Risk of Fire
Summary
• Warning Risk of Fire: DO NOT PLACE FLAMMABLE or COMBUSTIBLE MATERIALS near the projector! Create an “exclusion
zone”, must be greater than 40 cm (16”) for all DLP Cinema projectors, NOT LESS.
• The exclusion zone on the lens side must be at least 5 m (200”).
• Do not cover the projector or the lens with any m aterial while the projector is in operation.
• Install the projector in a well ventilated area away from sources of ignition and out of direct sunlight.
• In the event of fire, use sand, CO2 , or dry powder fire extinguishers; NEVER use w
ater on an electrical fire.
• Always have service on this projector performed by authorized Barco service personnel.
1.3 Ventilation
Slots and Openings
Slots and openings in the cabinet are provided for ventilation. To ensure reliable operation of the projector and to protect it from
overheating, NEVER cover or block these openings.
Projector room
Projection room must be well ventilated or cooled in order to avoid build up of heat. It is necessary to vent hot exhaust air from
console to the outside of the building.
The minimum exhaust airflow requirement is 10-15 m3/min or 350–530 CF M.
Projector damage
If the air filters are not regularly cleaned or replaced, the air flow inside the projector could be disrupted, causing overheating.
Overheating may lead to the projector shutting down during oper
ation.
R5976907 D-CINE PREMIERE DP100 02/11/2005
3