Filter
Top Products
28
With time tag enabled, a MM/DD/YY HH/MM/SS entry is appended to all samples,
where MM is the month, DD is the day, YY is the year, HH is the hour, MM is the
minute, and SS is the second according to the base unit's time-of-day clock.
5.1.4.6 TERMINATING CHARACTER(S)
By responding to the Enter Selection: message at the end of the Reporting Setup
Menu on page 26 with "7" (Terminating Character(s)), you may program one or
two characters to be appended at the end of each event sample. This option
allows a user to match the host terminal and/or requirements of their application
software. The PDI will respond with the Enter Terminating Character menu as
follows:
ENTER TERMINATING CHARACTER
Terminating Character(s)...........0D0A
Enter 1 or 2 Terminating Characters in Hex Format
(i.e. 0D0A for CR+LF) <cr>, or X to Exit:
Type the hexadecimal representation of the desired terminating character(s). For
example, Carriage Return would be represented by 0D Hex and Line Feed would
be represented by 0A Hex.
NOTE: Only ASCII characters A-F and 0-9 are acceptable.
5.1.5 DYNAMIC CONFIGURATION
By responding to the Enter Selection: message at the end of the Configuration
Main Menu (see Section 5.1.1) with "5" (Dynamic Configuration), you may
program the PDI to respond to dynamic configuration (non-verbose) commands.
The PDI will respond with the Dynamic Configuration Commands menu as
follows:
DYNAMIC CONFIGURATION COMMANDS
Dynamic Configuration Commands.....DISABLED
Enable.............................1
Disable............................2
Exit...............................X
Enter Selection: