Filter
Top Products
Documentation Number 3PCISD4x-3903 Manual Chapter 3 29
B&B Electronics Mfg Co – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104
B&B Electronics Ltd – Westlink Comm. Pk. – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445
10. This driver does not require re-booting to complete installation.
11. Open the Control Panel, select Ports.
12. Verify 4 new COM Ports (COM5, COM6, COM7, COM8).
If you have 4 new COM ports, the installation is complete. Select
one of the new ports, select Settings, Advanced. You should obtain
the message, "There are no user configurable advanced I/O
parameters for this COM port."
Check the ports with your software or with a Loopback test (see
page 33).
Note: In the above example, a serial mouse is connected to the port
which would usually be COM1. NT does not show it. COM2 is the
second built-in serial port.
30 Chapter 3 Documentation Number 3PCISD4x-3903 Manual
B&B Electronics Mfg Co – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104
B&B Electronics Ltd – Westlink Comm. Pk. – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445
You can check details of the serial card setup using Windows NT
Diagnostics, found under Administrative Tools. This can show the
Resources used such as addresses and IRQ.
Windows Diagnostics will not allow changing anything.
The above shows the 4 ports using the PCI card interrupt.