Filter
Top Products
ENGLISH
V-AMP 3 User Manual
4
Strain relief clamp
Sleeve
Tip
Sleeve
(ground/shield)
Unbalanced ¼" TS connector
Tip
(signal)
Right channel
Left channel
Tip
Tip
Tip
Sleeve
Sleeve
Ring
Sleeve
¼" TRS to stereo RCA
Controls and Connectors
Front panel
GAIN – Adjusts the distortion level of an amp simulation. 1.
TREBLE – Adjusts the upper frequencies of the guitar tone. 2.
MID – Adjusts the mid range frequencies. 3.
BASS – Adjusts the low frequencies. 4.
VOLUME – Adjusts the volume level of the current preset. This will 5.
allow you to keep the volume even between various presets.
MASTER – Adjusts the overall output to the PHONES and LINE OUT. 6.
AMPS – Selects the amp simulation. Hold the TAP button while 7.
turning the AMPS knob to select one of the 17-32 amp models
(grey lettering).
Each LED ring around the VOLUME, BASS, MID, TREBLE, GAIN, •
EFFECTS and REVERB knobs has nine LEDs. Either one LED or two
neighboring LEDs (in between position) will light on each ring,
indicating a total of 17 positions per knob.
If the TAP button is held down, the TREBLE knob functions as a •
PRESENCE control. This allows you to add or remove a high-end
“shimmer” in the amp tone.
PRESET BUTTONS – Recall saved presets within a bank. These 8.
buttons also select various categories in EDIT mode and allow
access to Configuration mode. (see EDIT mode and Configuration
mode sections)
1
7 8
6
10
9
11
2
13
4
3
5
12
14
15