Filter
Top Products
27
Telephone Interface
You must have the optional phone card installed inside
the ePowerSwitch Server for all the functions discussed
here. Please check the dealer for the detail information.
Telephone access interface
1. Dial up the ePowerSwitch.
2. After three sequence rings, the ePowerSwitch will respond
by sending out 3 short beeps to the caller and waiting for
user to enter password.
3. User enters access password. The default password is
123456789#.
4. The ePowerSwitch will send out
a. 3 short beep to confirm successful login.
b. A long beep to deny access.
5. Once logged in, remote user can change ID Address:
333XXxx# is Change ID Address Command.
XX is Current Address, xx is Change ID Address.
Eg, 3330001# change ePowerSwitch ID from 0 to 1.
The default ID address for ePowerSwitch is 0.
The valid ID address for ePowerSwitch is 1, 2…16. The ID
address set for ePowerSwitch in daisy chain needs to be
different.
Note: If you had setup ePowerSwitch ID from by web, you
do not need to change ID here.
6. Once logged in, remote user can punch in 4 digits