Filter
Top Products
2
2
?? Works with all major NMSs on Ethernet—
ePowerSwitch System works with the most widely used
Network Management Systems: HP Open View, Sun
NetManager, IBM NetView, and many more.
?? Remote Firmware upgrade support - The
ePowerSwitch System supports firmware upgrade through
TFTP server remotely. A serial upgrade method is
available too.
?? Ring On or Reset adapter
Status LEDs
– Three LED indicators:
Red LED – indicates the ON/OFF status for each of the rear
output socket respectively from A to H
Green LED – indicates the Internet (remote) control or non
Internet (front panel) control status of the corresponding
socket. You may change this status by pressing and holding
the button for 3 seconds till the LED blinking then release the
button.
Yellow LED – indicates the number of ePowerSwitch
connected to NIC. The first one always has NIC built-in. The
rest of the ePowerSwitch doesn’t have NIC (device
2,3,4,…up to 16). They are connected through iLink port via
iLink cable line.
Switch
Master Switch – controls the power for the entire unit.