Filter
Top Products
1
2
3
4
5
6
7
8
section
9
Installation
Connecting Computers to the E Series KVM
Switch
Step 1
Make sure your computer is powered off.
Step 2
Using the Belkin E Series Cable Kit for PS/2 (F1D9002x06), connect the VGA
connector to the monitor port on your computer. (Refer to diagram below.)
Step 3
Connect the PS/2 mouse and keyboard connectors to the mouse and keyboard
ports on the computer. (Refer to diagram below.)
Step 4
Connect the Belkin E Series Cable Kit for PS/2 to the desired PC port on the rear
of the E Series KVM Switch. (Refer to diagram below.)
CONSOLE PC 4 PC 3 PC 2 PC 1
Step 5
Power up your computer.
Step 6
Repeat Steps 1 through 5 for each additional PS/2 computer you wish
to connect.