Filter
Top Products
Operation28
If you forget the password
If the password function is activated, you will be asked
to enter the six-digit password every time you turn on
the projector. If you enter the wrong password, the
password error message as pictured to the right
displays lasting for three seconds, and the INPUT
PASSWORD message follows. You can retry by
entering another six-digit password, or if you did not
record the password in this manual, and you absolutely do not remember it, you can use
the password recall procedure. See "Entering the password recall procedure" on page 28
for details.
If you enter an incorrect password 5 times in succession, the projector will automatically
shut down in a short time.
Entering the password recall procedure
1. Press and hold AUTO on the projector or
remote control for 3 seconds. The projector
will display a coded number on the screen.
2. Write down the number and turn off your
projector.
3. Seek help from the local BenQ service center
to decode the number. You may be required
to provide proof of purchase documentation
to verify that you are an authorized user of
the projector.
Changing the password
1. Open the OSD menu and go to the SYSTEM SETUP: Advanced> Security Settings
> Change Password menu.
2. Press Mode/Enter. The message "INPUT CURRENT PASSWORD" displays.
3. Enter the old password.
• If the password is correct, another message "INPUT NEW PASSWORD"
displays.
• If the password is incorrect, the password error message displays lasting for
three seconds, and the message "INPUT CURRENT PASSWORD" displays
for your retry. You can press Menu/Exit to cancel the change or try another
password.
4. Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected
password down here in this manual in advance or right after the password is entered so that it
is available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
5. Confirm the new password by re-entering the new password.
6. You have successfully assigned a new password to the projector. Remember to enter
the new password next time the projector is started.
Password Error
Please try again.
Please write down the recall code,
and contact BenQ
Customer Center.
Recall Code:
0 2 1 2
RECALL PASSWORD
Exit