Filter
Top Products
Important safety instructions4
Safety Instructions (Continued)
7. When the auto blank sensor does
not work and the projector is under
operation, do not block the
projection lens with any objects as
this could cause the objects to
become heated and deformed or
even cause a fire. To temporarily
turn off the lamp, press BLANK on
the projector or remote control.
8. The lamp becomes extremely hot
during operation. Allow the
projector to cool for approximately
45 minutes prior to removing the
lamp assembly for replacement.
9. Never replace the lamp assembly or
any electronic components unless
the projector is unplugged.
10. Do not operate lamps beyond the
rated lamp life. Excessive operation
of lamps beyond the rated life
could cause them to break on rare
occasions.
11. Do not place this product on an
unstable cart, stand, or table. The
product may fall, sustaining serious
damage.
12. Do not stand the projector on end
vertically. Doing so may cause the
projector to fall over, causing injury
or resulting in damage to the
projector.