Filter
Top Products
Maintenance48
Maintenance
Care of the projector
Your projector needs little maintenance. The only thing you need to do on a regular basis is
to keep the lens clean and to clean the dust filters to prevent overheating.
See "Cleaning the lens" and "Cleaning and replacing the dust filters" below for details.
Never remove any parts of the projector except the lamp and dust filter. Contact your dealer
if other parts need replacing.
Cleaning the lens
Clean the lens whenever you notice dirt or dust on the surface.
• Use a canister of compressed air to remove dust.
• If there is dirt or smears, use lens-cleaning paper or moisten a soft cloth with lens
cleaner and gently wipe the lens surface.
Never rub the lens with abrasive materials.
Cleaning the projector case
Before you clean the case, turn the projector off using the proper shutdown procedure as
described in "Shutting down the projector" on page 40.
• To remove dirt or dust, wipe the case with the supplied cleaning cloth.
• To remove stubborn dirt or stains, moisten a soft cloth with water and a neutral pH
detergent. Then wipe the case.
Never use wax, alcohol, benzene, thinner or other chemical detergents. These can damage the
case.
Storing the projector
If you need to store the projector for an extended time, please follow the instructions below:
• Make sure the temperature and humidity of the storage area are within the
recommended range for the projector. Refer to "Specifications" on page 57 or consult
your dealer about the range.
• Retract the adjuster feet.
• Remove the batteries from the remote control.
• Pack the projector in its original packing or equivalent.
Transporting the projector
It is recommended that you ship the projector with its original packing or equivalent. When
you carry the projector yourself, please use the original box or provided soft carry case.
Cleaning and replacing the dust filters
It is necessary to clean the dust filters periodically. If the filters are not cleaned, they can
become clogged with dust and prevent proper ventilation. This can cause overheating and a
malfunction of the projector.