Filter
Top Products
Best Data DSL542 ADSL Ethernet Router User’s Guide
45
Adding ATM VCCs
You may need to create a VCC if none has been predefined on your system or if you use multiple
services with your ISP. Each service may require its own VCC. Follow these instructions to add a
VCC:
1. From the ATM VCC Configuration page, click
.
The ATM VCC – Add page displays, as shown in Figure 35
Figure 34. ATM VCC – Add Page
2. Select an interface name from the VCC Interface drop-down list.
3. Enter the VPI and VCI values assigned by your ISP, and select the mux type from the
drop-down list.
4. Click
.
5. On the confirmation page, click
to return to the ATM VCC Configuration page.
6. Click the Admin tab, and then click
Commit & Reboot in the task bar.
7. Click
to save your changes to permanent memory.
The new interface should now display in the ATM VCC Configuration table.
You may need to create a new WAN interface, or modify an existing interface, so that it uses the
new VCC. See the instructions for configuring a PPP (Chapter 10), EoA (Chapter 11), or IPoA
(Chapter 12) interfaces, depending on the type you use to communicate with your ISP.
You can verify that the new settings work by attempting to access the Internet from a LAN/USB
computer. Contact your ISP for troubleshooting assistance.