Filter
Top Products
Billion BIPAC 7100SV VoIP ADSL Router
6
2.3 The Rear Ports
LED Meaning
Power Switch A Power ON/OFF switch
Power Jack
Connect the supplied power adapter to this jack.
Reset Press it to restore the factory default setting back.
VoIP
Connect RJ-11 cable to this port when connecting to an analog phone
set.
LAN
(RJ-45
connector)
Connect the supplied Ethernet cable to this port when connecting to a
NIC (Network Interface card) in PC.
Connect an UTP Ethernet cable to this port when connecting to a LAN
such as an office or home network.
LINE
(RJ-11
connector)
Connect the supplied RJ-11 cable to this port when connecting to the
ADSL
2.4 Cabling
The most common problem associated with Ethernet is bad cabling or ADSL line. Make sure that all
connected devices are turned on. On the front of the product is a bank of LEDs. As a first check, please
verify that the PWR, LAN and ADSL LEDs are lit and SYS LED is blinking. If they are not, verify that you
are using the proper cables.
So long as the cables are connected and the LEDs are lit normally, follow “Chapter 3 Configuration”
below to modify the network settings.