Filter
Top Products
2.4The Rear Ports
2
1
4
3
Port Description
1 DC 12V/1A
Connect the supplied power adapter to this jack.
2 RESET
After the router is powered on, press this recessed button using
the end of paper clip or other small pointed object to reset the
router or to restore it to factory default settings.
1. Recovery procedures for non-working routers (e.g. after a
failed firmware upgrade flash):
Hold the Emergency/Failure Recovery Button on the back of the
modem in. Keep this button held in and turn on the modem. Once
the lights on the modem have stopped flashing, release the
Emergency/Failure Recovery Button. The modem's
emergency-reflash web interface will then be accessible via
http://192.168.1.254/ where you can upload a firmware image to
restore the modem to a functional state. Please note that the
modem will only respond via its web interface at this address,
and will not respond to ping requests from your PC or to telnet
connections.
2. Recovery procedures for a lost web interface password:
After turning the router on press the Emergency/Failure
Recovery Button on the back of the modem, and hold the button
in until all lights on the modem flash and it reboots with factory
default settings. The login will be reset to admin and the
password will be reset to admin, and the modem will be
accessible via its default IP address at http://192.168.1.254/
3
LAN
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the
four LAN ports when connecting to a PC or an office/home
network of 10Mbps or 100Mbps.
4
ADSL
Connect the supplied RJ-11 (telephone) cable to this port when
connecting to the ADSL/telephone network.
9