Black Box ACU1028A Network Hardware User Manual


 
OVERVIEW
16
2.6 How to Use This Guide
This guide describes the installation and configuration of Standard and Serial members of the
ServSwitch™ Brand CAT5 KVM Extender range. Although the connection and operation of
these systems is relatively straightforward, you should consider the following before getting
started:
Connection & Compatibility
If you have purchased an Extender kit, this will contain all the cables required to connect the
Local Unit to your PC or KVM switch. The remote console (keyboard, monitor and mouse)
and any serial equipment connect directly to the Remote Unit.
If you have purchased a Remote Unit, ensure that it is compatible with your Local Unit or hub
(see Extender Compatibility, page 15).
For information about connection and installation, see Installation, page 17.
Interconnection Cable
You will need CATx cable, terminated with RJ45 plugs, to connect the Local and Remote
Units (see Interconnection Cable Requirements, page 18).
Adjusting Video
Video signals become distorted when transmitted over CATx cable. To get the best from your
extender system, it is essential that you adjust the Remote Unit to optimize the video image
quality:
For experienced users, there is a Quick Setup section at the start of this guide (see page
10).
For the full procedure, see Remote Unit Configuration & Operation, page 28.
Refer to Appendix C: Advanced Cabling Issues (Skew), page 45 for a more in depth
discussion of skew correction and advanced cabling issues.