Filter
Top Products
Auto-Sync Time Clock
6-8 724-746-5500 | blackbox.com
NOTE: An error message can be cleared by removing the cover and pressing the
“Reset” button (see Figure 6-9). The Reset button will NOT clear the
configuration and/or transaction information (i.e., DST & print line styles)
stored in the clock flash memory. Conversely, it is not recommended to
clear an error by using the Reset command from the clock web interface as
this could reset the clock configuration.
Figure 6-9. Reset Button Location.
Table 6-1. Error Messages.
Error
Message
Cause Solution
L0 bA
Discharged FPR
battery.
FPR battery cable
not connected.
No AC power.
Verify that the battery cable for the FPR is
connected and connect the power cord to AC
source. Allow FPR battery to recharge for 24
to 48 hours.
E r Pr General Print Error.
Unlock cover and remove. Press the Reset
button (see Figure 6-9). If the error clears,
try to stamp a card. If the unit stamps
without having the error message come up
again replace the cover and lock. The
configuration is still programmed in the
clock.
E I Pr
Home Sensor
Motor, Carriage
Stuck.
Unlock cover and remove. Set Auto-Sync
Time Clock on side with the ribbon side up.
Press the Reset button to reset the printer
carriage and blow air into the printer platen
to remove or dislodge jammed objects
(i.e., staples).