Filter
Top Products
724-746-5500 | blackbox.com
Page 18
Chapter 2: Overview
2.6.5 EDID Copy
Copying the EDID will enable the receiver to send correct resolutions to your output.
Although the default EDID will work in most cases, some monitors will not work
with it.
NOTE: EDID copy is required for DVI monitors.
To copy the EDID:
1. To copy EDID from a specific receiver to a specific transmitter, both receiver and
transmitter must be configured to the same channel.
2. Hold down the function button on the receiver and plug in the power.
3. Continue to hold down the function button until the network LED starts blinking.
EDID is now copied to the receiver.
2.6.6 Reset Button
To reset the system, press the “Reset” button once. The system will start to reset
after a short press on the reset button.