Filter
Top Products
10/100Base-TX Hardened PoL/PoE Ethernet Extender
User’s
Manual
3
Power Input Assignment
Power1 48VDC DC Jack
T:46-57V / R:46-57V DC
Power2
Power Ground
T:46-57V / R:46-57V DC
Power3
Power Ground
Earth Ground
Terminal
Block
DIP Switch Down Up
Transmitter
PoL Disable Power over Link Enable Power over Link
Type
Std (Standard)
Standard line speed
Better noise immunity
Per (Performance)
Better line speed
Poor noise immunity
Receiver
Mode
Loc (Local)
Set Receiver to Local Mode
Rmt (Remote)
Set Receiver to Remote Mode
Type
Std (Standard)
Standard line speed
Better noise immunity
Per (Performance)
Better line speed
Poor noise immunity
LEDs State Indication
Steady Power received Power
1/2/3
Off Power off
Steady Power Ethernet extension interface function is enabled
PoL
Off
No power is transmitted over Ethernet extension
interface
Steady Powered device (PD) is connected
PoE
Off Powered device (PD) is disconnected
Steady A valid Extender connection is established
Fast
Flashing
Data is being transmitted or received
Slow
Flashing
Extender port under negotiation mode
Link
Off Extender interface connection is not established
Line
Speed
Steady Displays the link speed in Mbps
Steady PoE power can be transmitted for PD PSE
Output
All off No PoE power can be transmitted for PD
Steady A valid Ethernet connection established
Flashing Data transmitted or received
Green
Off Non-Ethernet connection is established
Steady Link speed at 100Mbps
Yellow
Off Link speed at 10Mbps