Filter
Top Products
Express Ethernet Switch LB9217A-R2 & Applicable Modules
14
Module Installation
The installation for 8-port module and single-port module is the same. Take single-port
fiber module for example.
y Remove the module from the static-free container.
y Unscrew the cover plate of the expansion slot. The slot for
single-port module is located at the right side of the switch.
y Remove the plate and keep it for future use when you decide to
remove this module.
y With the power off, slide the module into the desired slot, following the internal
plastic guide rails.
y Once it is slid in fully, snap in the module to make a proper connection and fasten
the screws.
y Finally, turn on the power.
y Consult the following illustrations before installation.
<NOTE> Before you start with any installation, ensure that the power is off.
The module is not hot swappable.
Figure 4: Removal of cover plate Fiber module being installed