Filter
Top Products
Example: Typical Alarm Trigger Configuration
In this case, the Dinion camera is used to watch for motion.
When the camera detects motion it sends an alarm to the UML
monitor. The monitor, then, switches the input to display the
video from the Dinion camera and sounds a buzzer.
1. Route the coax cable from the Dinion Video output to the
AV1 input of the UML monitor.
2. Configure the following settings for the Dinion camera:
VMD: OSD
Area: 1
Active: On
3. Connect one flying lead to relay output three, on the back
of the Dinion camera, and connect the other to relay output
four.
4. Connect the other end of the Trigger Relay cable to the
Trigger Input connector on the back of the monitor.
5. Plug the monitor into a power socket; then press the Power
button.
6. On the monitor, access the Trigger menu:
Press the Menu button.
Press the Down arrow button to access the Setting menu.
Press the Right arrow button to enter the Setting menu.
Press the Down arrow button until Trigger is highlighted;
then press the Right arrow button.
7. Make the necessary changes to the Trigger menu so that
the settings match the following:
Bosch High Performance
HD LED Monitors
Installing the Monitor | en 33
Bosch Security Systems, Inc. Installation Manual 2013.02 | 3.0 |