Filter
Top Products
TM
SLE100 Installation Manual
11 590-00532, rev A
1. Install 4 mounting bolts in the wall at the desired location. The template provided in Figure 3-3
can be used to establish the hole pattern on the wall. The bolts (normally ⅜-16) should extend
0.8 to 3.0 inches (2cm to 7.5cm) from the wall and be strong enough to secure the radio to the
wall under foreseeable environmental conditions. The environmental conditions may include,
but not limited to, wind, rain, ice, etc. Depending on the wall material the mount is being
attached to, a different size bolt may be appropriate. In this case, bolts up to ¾ inch in diameter
may be used.
1. Secure the ‘Wall-Mounting Bracket’ to the wall using the appropriate sized nuts, lock washers,
and flat washers for the bolts used.
2. Attach the Yoke Mounting Bracket to the mount, with Teflon shim in-between, using 2 each of
the supplied ⅜-16 x ¾ bolts, ⅜ lock washers, and ⅜ flat washers. Tighten the bolts just enough
to allow the yoke to move back and forth without binding.
Figure 3-2 Attaching the Yoke to the Mounting Bracket
3/8-16x3/4 Bolts
Mountin
g
Bracke
t
Teflon Shi
m
Radio Yoke
3/8 Lock Washe
r
3/8 Flat Washe
r