Broadband Products AMC-6 Network Router User Manual


 
4. This will bring up the Data Services window as shown in Figure 4-33. First check to make sure
that the MAC Source is set to User Defined IP. If it isn’t, left click on the down arrow to
display a drop down menu. Highlight User Defined IP and left click on it. Next, you will type in
your IP address, which was provided to you when you first called in after receiving your
equipment. Please type it in carefully as this is critical for proper operation. Finally, you will
type AE for the MAC Address location (Figure 4-33). Once this is completed, left click on the
Apply button, then on the OK button to close the window (Figure 4-34).
Figure 4-33
Figure 4-34
5. Finally, left click on Close on the Setup4PC window (Figure 4-35).
30