Filter
Top Products
Installing External USB Satellite Modem
To install the external USB satellite modem, do the following steps. There’s no need to turn off the
computer at this time.
1. Connect the power cord, one end to the power outlet, the other to the DC IN connector on the back
of the external USB satellite modem.
2. Connect the external USB satellite modem cable, one end to the USB port on the PC. DO NOT
connect the other end to the USB port on the back of the external USB satellite modem yet.
3. Connect the coaxial cable from the satellite dish to the female plug on the TechniSat modem you
just installed.
2 Installing Drivers
(*The PCI and USB drivers are located on the CD supplied with your B2C2 satellite modem. It is
necessary to install the modem and drivers prior to installing the satellite software) Our drivers
support Windows XP and Windows 2000 Professional. The procedure for the driver installation for the
Internal PCI satellite modem and the External USB satellite modem are the same. If installing the
External USB satellite modem drivers, plug in the USB cable into the back of the B2C2 satellite
modem at this time.
Windows XP
To install the B2C2 satellite modem driver on Windows XP, you must be logged on as an
Administrator or have Administrator Privileges.
1. When you start your computer for the first time after installing the B2C2 internal PCI satellite
modem, or after plugging in the external B2C2 USB satellite modem, the Plug-N-Play feature
should recognize the new modem installed (Figure 2-1).
Figure 2-1
5