Filter
Top Products
NOTE
If you have configured interfaces for standard PIM (dense mode) on the device, statistics for these
interfaces are listed first by the display.
The following table describes the output for this show command.
Output from the show ip pim vrf traffic command TABLE 13
This field... Displays...
Port The port or virtual interface on which the PIM interface is configured.
Hello The number of PIM Hello messages sent or received on the interface.
J or P The number of Join or Prune messages sent or received on the interface.
NOTE
Unlike PIM dense, PIM Sparse uses the same messages for Joins and Prunes.
Register The number of Register messages sent or received on the interface.
RegStop The number of Register Stop messages sent or received on the interface.
Assert The number of Assert messages sent or received on the interface.
Total Recv or Xmit The total number of IGMP messages sent and received by the device.
Total Discard or chksum The total number of IGMP messages discarded, including a separate counter for those
that failed the checksum comparison.
Clearing the PIM message counters
You can clear the PIM message counters using the following command.
device# clear ip pim traffic
Syntax: clear ip pim [vrf vrf-name ] traffic
Use the vrf option to clear the PIM message counters for a VRF instance specified by the vrf-name
variable.
Clearing the PIM message counters
120 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02