Filter
Top Products
Field Displays
get-mem The current memory allocation. This number should continue to increase.
size The size of a unit (in bytes).
init The initial allocated amount of memory.
NOTE
This number can be increased. (More memory can be allocated if necessary.)
Available vidx The output interface (OIF) port mask used by mcache. The entire device has a maximum of 4096
vidx. Different mcaches with the same OIF share the same vidx. If vidx is not available, the stream
cannot be hardware-switched.
Displaying status of MLD snooping traffic
To display status information for MLD snooping traffic, enter the show ipv6 multicast traffic command.
device#show ipv6 multicast traffic
MLD snooping: Total Recv: 32208, Xmit: 166
Q: query, Qry: general Q, G-Qry: group Q, GSQry: group-source Q, Mbr: member
Recv QryV1 QryV2 G-Qry GSQry MbrV1 MbrV2 Leave
VL1 0 0 0 0 31744 208 256
VL70 0 0 0 0 0 0 0
Recv IsIN IsEX ToIN ToEX ALLOW BLOCK Pkt-Err
VL1 1473 31784 0 1 1 7 0
VL70 0 0 0 0 0 0 0
Send QryV1 QryV2 G-Qry GSQry MbrV1 MbrV2
VL1 0 0 166 0 0 0
VL70 0 0 0 0 0 0
Syntax: show ipv6 multicast traffic
The following table describes the information displayed by the show ipv6 multicast traffic command.
Field Description
Q Query
Qry General Query
QryV1 Number of general MLDv1 queries received or sent.
QryV2 Number of general MLDv2 snooping queries received or sent.
G-Qry Number of group specific queries received or sent.
GSQry Number of group source specific queries received or sent.
MBR The membership report.
MbrV1 The MLDv1 membership report.
Displaying status of MLD snooping traffic
FastIron Ethernet Switch IP Multicast Configuration Guide 59
53-1003085-02