Filter
Top Products
e1/1/2 0 2 - Self 0 0 No
v220 0 2 - Disabled
e1/1/1 3 2 - Self 0 12 No
Syntax: show ipv6 mld [ vrf vrf-name ] interface [ ethernet port-number | ve num ]
The vrf parameter allows you to display MLD parameters on an interface for the VRF instance identified
by the vrf-name variable.
Enter ve and its number, or ethernet and its port address to display MLD information for a specific
virtual routing interface or an Ethernet interface.
The following table displays the output from the show ipv6 mld interface command.
Output from the show ipv6 mld interface command TABLE 42
Field Description
version Version of the MLD being used.
query int Query interval in seconds.
max resp time Number of seconds multicast groups have to respond to queries.
group mem time Number of seconds multicast groups can be members of this group before aging out.
(details) The following is displayed for each interface:
• The port ID
• The default MLD version being used
• The multicast protocol used
• IPV6 address of the multicast interface
• If the interface has groups, the group source list, IPv6 multicast address, and the filter mode
are displayed.
To display the MLD parameters on an interface for a specified VRF, enter the following
command as shown in the example below.
device(config)# show ipv mld vrf public interface
---------+------+---------+---------------------------------------+---------+-----
+---------
Intf/Port|Groups| Version |Querier | Timer |V1Rtr|
Tracking
| | Oper Cfg| | OQrr
GenQ| |
---------+------+----+----+---------------------------------------+----+----+-----
+---------
v6 0 2 -
Disabled
e5/1 2 - fe80::20c:dbff:fee2:5000 11 0 No
v61 0 2 -
Disabled
e11/1 2 - Self 0 122 No
Displaying MLD settings
To display MLD settings for the "eng" VRF, enter the following command.
device# show ipv6 mld vrf eng settings
MLD Global Configuration
Query Interval : 125s Configured Interval : 125s
Displaying MLD settings
FastIron Ethernet Switch IP Multicast Configuration Guide 203
53-1003085-02