Brother LX-900 Laminator User Manual


 
- 21 -
(5) Press Start.
The document is fed into the machine. The
machine will automatically start to detect the
top and side edges of the document. The
green light of the Start button will blink during
the finishing process. The top edge of the film
will automatically be cut off when the Cut
Mode is selected.
(6) The document is ejected through the
document output area when the process is
complete. If the document is longer than 13.8”,
the job will stop and the “Start” button blinks
orange. Press “Start” to continue the process.
CAUTION:
Do not attempt to remove or pull on the document while the machine is operating.
Do not turn the machine off during a job except in the event of a malfunction.
Do not place the next document on the document tray until the current operation is completed.
Note
To stop the operation, press Start. (The button will light up red.) Press Start
again to restart the operation
or use Feed and to feed/cut the document manually.
To avoid the accidental cut off, you will have to press more than 2 seconds.
Note
The buzzer sounds if the document was not
set properly. Reset the document and press
Start again.
Note
If you use adhesive back laminate film, the
back surface of laminated document will be
the liner to be peeled off. To mount the
laminated document on a surface for display,
peel of the liner as illustrated.
Note
If you use the magnetic back laminate film,
you can put the output on the metal surface
objects.
The back surface of laminated output (magnet
side) will be the liner to be peeled off.
Please peel off the liner gently as illustrated
when putting the output sheet.