Filter
Top Products
10 - 20 FRONT PANEL SETUP MENU
2
Press or to select On or Off.
3
Press Set.
4
Press Stop/Exit.
DLC/LLC
1
(For MFC) Press Menu, 6, 6, 4.
(For DCP) Press
Menu, 4, 2, 4.
2
Press or to select On or Off.
3
Press Set.
4
Press Stop/Exit.
Net BIOS/IP
The NC-9100h Print / Fax Server supports SMB (Server Message
Block) over the TCP/IP protocol via the NetBIOS interface. This
means that just like regular Windows
®
PC's the Brother DCP/MFC
can appear in your network neighborhood. The main advantage of
NetBIOS printing is that you are able to print from legacy DOS
applications that are running on PC’s that are connected to Microsoft
networks.
1
(For MFC) Press Menu, 6, 6, 5.
(For DCP) Press
Menu, 4, 2, 5.
2
Press or to select On or Off.
3
Press Set.
4
Press Stop/Exit.
Ethernet
Ethernet link mode. Auto allows the print server to operate in
100BaseTX full or half duplex, or in 10BaseT half duplex mode by
auto negotiation.
100BaseTX Full Duplex (100B-FD) or Half Duplex (100B-HD) and
10BaseT Full Duplex (10B-FD) or Half Duplex (10B-HD) fix the print
server link mode. This change is valid after the print server has been
reset.
If you incorrectly set this value, you may not be able to
communicate with your print server.