Brother Multi-Protocol On-board Ethernet Print Server and Wireless Ethernet Server User Manual


 
32
Configuring your machine for a wireless network (For HL-5470DW(T) and HL-6180DW(T))
3
Configuration in Ad-hoc mode (For IEEE 802.11b) 3
Using configured SSID 3
If you are trying to pair the machine to a computer that is already in Ad-hoc mode with a configured SSID,
you will need to complete the following steps:
a Before configuring your machine we recommend you write down your wireless network settings. You will
need this information before you continue with the configuration.
Check and record the current wireless network settings of your computer you are connecting with.
Note
The wireless network settings of the computer you are connecting with must be set to Ad-hoc mode with
a SSID already configured. For instructions on how to configure your computer to Ad-hoc mode please
see the information included with your computer or contact your network administrator.
For example: 3
Note
Your Brother machine supports the use of the first WEP key only.
b Press a or b to choose Network.
Press OK.
c Press a or b to choose WLAN.
Press OK.
d Press a or b to choose Setup Wizard.
Press OK.
e When WLAN Enable? is displayed, press a to accept.
This will start the wireless setup wizard.
To cancel, press Cancel.
Network name: (SSID)
Communication Mode Encryption mode Network key
Ad-hoc NONE
WEP
Network name: (SSID)
HELLO
Communication Mode Encryption mode Network key
Ad-hoc WEP 12345