Filter
Top Products
8
◗ DSL
Select this option if your internet
connection is provided by a
DSL provider. Most DSL providers
require PPoE settings to be entered.
◗ Cable
Select this option if your internet
connection is provided through your
cable provider. Most cable providers
require no aditional settings except to
obtain an IP.
■ NOTE: After selecting either the DSL or Cable wizard, please choose
the proper selections that are applicable to your internet service provider. A
verification test will be run at the end of the wizard.
◗ Advanced
Select this option for advanced settings of your AirStation. For more information
on configuring advanced settings of your AirStation, please refer to the User
Manual on the CD-ROM or the Buffalo Wireless Support Web Site:
http://www.buffalo-technology.com
◗ Default Settings
If at any time you wish to restore settings to factory defaults, press the INIT /
AOSS button on the rear side of the AirStation for 6 seconds (AirStation must
be powered on). During this process the red DIAG light will be turned off after
flashing rapidly. Once the Red DIAG light has stopped flashing, the AirStation
has completed restoring its settings.
This completes the basic AirStation Configuration. To change advanced settings,
please consult the Online Manual on the CD-ROM or go to the Buffalo Support
Web Site: http://www.buffalo-technology.com
The first page of the configuration offers 3 distinct buttons for DSL, Cable, and
Advanced settings. Select the appropriate type of internet service, referencing
the information you collected during the preparation steps if needed.
For future access to configuration, bookmarking this page is recommended