Buffalo Technology WLI-TX4-G54HP Network Router User Manual


  Open as PDF
of 13
 
3
AOSS Installation
If your Wireless Router/Access Point supports AOSS, then AOSS can
congure your wireless network for you. To use AOSS to connect your
Ethernet converter to your wireless network:
•
Conrm that the Wireless Router/Access Point and the Ethernet
Converter are both powered on.
•
Hold down the AOSS button on the Wireless Router/Access Point for 3
seconds.
•
Hold down the AOSS button on the Ethernet converter for 3 seconds.
AOSS will take about a minute to
congure your wireless network. When
nished, the AOSS LEDs on both the
Wireless Router/Access Point and the
Ethernet Converter will stop blinking
and stay lit. You now have a secure
connection!
NOTES:
If AOSS is used, then any non-AOSS wireless client devices in
your network will have to be manually re-congured to connect to the
Router/Access Point in AOSS mode; please consult your Router/Access
Point documentation for more information on adding non-AOSS devices.
AOSS congures your SSID, encryption type, wireless channel,
and encryption key, and makes a secure connection between
your wireless components. You may need to run your router's
conguration utility to congure your internet connection before
using AOSS.
If AOSS does not nish properly, power cycle both the Router/Access
Point and the Ethernet Converter and attempt the AOSS process
again. AOSS works best when the router and the Ethernet Converter
are physically close. You can always move them further apart when
conguration is complete.
AOSS button
 previous next