Filter
Top Products
Device Configuration Menu Screen
2E42-27/2E42-27R/2E43-27/2E43-27R User’s Guide 5-15
The following briefly explains each screen accessible from the Device
Configuration Menu screen:
GENERAL CONFIGURATION
The General Configuration screen allows the user to monitor and
configure operating parameters for the 2E4X-27. For details, refer
to Section 5.7.
SNMP COMMUNITY NAMES
The SNMP Community Names screen allows the user to enter new,
change, or review the community names used as access passwords for
device management operation. Access is limited based on the password
level of the user. For details, refer to Section 5.8.
SNMP TRAPS
The SNMP Traps screen provides display and configuration access to the
table of IP addresses used for trap destinations and associated community
names. For details, refer to Section 5.9.
SWITCH CONFIGURATION
The Switch Configuration screen provides the basic setup options for
modifying switch operation in the network. For details, refer to
Section 5.10.
ETHERNET FULL DUPLEX CONFIGURATION
The Ethernet Full Duplex Configuration screen allows each 10 Mbps port
(1 to 24) to be set for either Standard Ethernet or Full Duplex operation.
The screen also indicates whether or not each port is linked to another
10BASE-T device and if that port is enabled. For details, refer to
Section 5.11.
SMARTTRUNK CONFIGURATION
The SmartTrunk Configuration screen allows the user to logically group
interfaces to aggregate high speed uplinks. Refer to the Cabletron
Systems SmartTrunk User’s Guide for additional information.
DEVICE SPECIFIC CONFIGURATION
The Device Specific Configuration Menu screen allows the user to select
screens to configure ports or check system resources specific to the
2E4X-27. For details, refer to Section 5.12.